Fuses and relays Mitsubishi Fuso Canter 7, 2002 - 2011

The 7th generation Mitsubishi Fuso Canter was produced in 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010 and 2011 with various versions of both the body and the cab. During this period, the model also underwent restyling. In this regard, there is no one general description of fuses and relays. In this material, we will consider the most common arrangement of electronic control units and the purpose of fuses and relays in them for Fuso Canter 7.

Check the purpose of the elements with your diagrams on the protective cover.

Boxes in cabin

The dashboard usually contains 2 relay and 1 fuse box.
General layout of control units in the passenger compartment

Decoding
A 05 idle speed control potentiometer
A 08 clutch switch
A 09 starter switch
A 10 switch combination
A 13 diagnostic connection
A 14 memory clear connection
A 19 accelerator pedal position sensor
C 01 instrument panel
J 02 connection connector
J 10 device connector Multi-Use tester
B 04 fuse box
B 05 engine ECU
B 06 diode
B 07 CAN resistor
B 09 resistor for regulating the number of injections of fuel
B 13 safety relay
B 18 ABS emission stop relay
B 19 glow plug relay

Fuse box


Remove the protective cover for access.


Example of a diagram from the block cover

Diagram
Amps / Description
A1 10A Cigarette lighter
A2 10A Audio
A4 10A Additional power supply (ACC ignition switch)
IN 1 15A Brake signal lamp
IN 2 10A Instrument cluster (EURO-3) Flow meter unit (EURO-4)
IN 3 15A Turn signal lamps
AT 4 10A Additional power supply (the circuit is directly connected to the battery)
AT 5 10A Audio
AT 6 10A Interior light
AT 7 25A Electric glass lift (driver)
AT 8 25A Electric glass lift (passenger)
AT 9 20A engine ECU
AT 11 15A Heated mirrors
B13 15A Diagnostic connector Tester
B14 15A Headlights (high beam)
B15 10A Left headlight (low beam)
B16 10A Right headlight (low beam)
B25 15A Rear lights
B26 15A Rear fog lamps
B27 10A Sound signal
B28 5A Air conditioner
B29 15A Air conditioner condenser fan
BZ0 15A Air conditioner fan, heater fan
B33 15A Fuel heater
B36 20A Exhaust gas recirculation motor Engine control unit
M1 10A Reversing lights
M2 10A Instrument cluster (EURO-3) Flow meter unit (EURO-4)
M3 15A Windscreen wiper and washer
М4 10A Auxiliary Power Supply (Ignition Switch Circuit ON)
M5 10A Exhaust gas recirculation control relay
М8 10A Exhaust brake
M9 5A engine ECU
M11 10A ABS
S1 10A Starter
* Spare fuse
1 5A Elimination of ABS faults (diagnostics)
2 10A Troubleshooting ABS (clear memory)
3 5A Troubleshooting engine ECU (diagnostics)
4 10A Eliminating engine ECU malfunctions (clear memory)

The fuse number A1 for 10A is responsible for the cigarette lighter.

Block near the battery


Another unit is attached to the outside of the car next to the battery.


Photo

Diagram
Amps / Description
B25 15A Rear lights
B26 15A Rear fog lamps
B27 10A Sound signal
B28 5A Air conditioner
B29 15A Air conditioner condenser fan
BZ0 15A Air conditioner fan, heater fan
B33 15A Fuel heater
B36 20A Exhaust gas recirculation motor Engine control unit
FH1 60A Fuse box (S1, A1-A4, M1-M12)
FH2 60A Fuse Box (B1-B11)
FH3 30A Fuse Box (B13-B16)
FH7 30A ABS engine
FH8 30A ABS Solenoid Switch
BATT1 120A Alternator

If the engine has a heating system and an indicator light and does not light up in cold weather, check for a blown heat relay fuse (1). If it is blown, disconnect the (-) wire from the battery and replace the fuse with a new 127A.

Related materials
Add new comment